MSP430 LAUNCHPAD UART DRIVER

The only way to know is to get into device manager and find out. Open Putty and select serial mode. They made some changes between rev 1. Both leds lights up, but when I try to communicate with my pc using the Emulator of the launchpad, I can not see the "A" in putty. We are not going to go into details on all the possible configurations, however you can read about it here if you are interested. Have a look at the interrupt tutorial! You should have serial access again.

Uploader:	Milmaran
Date Added:	18 March 2004
File Size:	70.5 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	39402
Price:	Free* [*Free Regsitration Required]

Share this post Link to post Share on other sites. Otherwise, the flag remains set after the ISR returns and the interrupt will immediately trigger and stay in a loop.

This register contains the data to send. We will now add some extra user-friendliness to our thermometer project.

Using the UART interface of the msp devices – VisualGDB Tutorials

Try entering some hexadecimal numbers in the terminal and see how the msp board increases them and sends them back. Also make sure it is null-terminated and pass it to the UART driver, i.

After you install them the UART device will have a port number assigned to it: Minicom is all command line, so if you are not comfortable with that, then you can install putty from the repositories. The minimum connection required for bidirectional communication is three signals: This means however that none of the standard header files are accessible, and therefore must all be redefined in your software. On some devices, half bits are supported as well, for example 1.

The table structure looks like this:. Yeah you will very likely not be enumerating your virtual com port on com To generate accurate 1MHz clock I am going to load the caliberation constants into the Basic clock system register and DCO control registers like this.

It mxp430 supports a callback function so you can have input processing functions when you receive data. Therefore the table will have only one entry as defined below: For now, the baud rate is the only member.

When you want to display a value, you usually use printf.

This may not be an issue for now since the code provided should work without modification, however it is ideal to have this capability. Before we begin, ensure that VisualGDB 4. If you uar to go back to serial, make sure mspdebug is closed, and unplug the Launchpad from the USB port.

When the character is sent by the UART module, the TX interrupt will happen again and the routine will be executed for the next character. The pitfall with both of the previous options is that you cannot use mspdebug and access the menu at the same time, making debugging difficult. Fortunately, the MSP Launchpad has a serial launchpax USB converter built right onto the the board so this additional equipment is not required.

Using the UART interface of the msp430 devices

There are five parameters which must be configured correctly to establish a basic serial connection:. Currently you have JavaScript disabled. The modulator will work roughly like this:. Then press F5 to start debugging and check the output in launchppad raw terminal window: This is the last episode in our little journey with the Launchpad.

If you want to go back to serial, you must close minicom, unplug the device, wait a few seconds and plug it back in again before opening minicom. This bit is used to put the USCI module in reset state. Here we have a 5 bit transmission with an odd parity. There are two variants of the USCI module each of which support specific interfaces:.

In Windows, if you check in the device manager, you will see that jart device is not found. Do you have any guidance, any tutorials or sites you know of that could jsp430 some guidance using this family of processors?